Prologix GPIB-USB Controller Uživatelský manuál stáhnout pdf (Strana 5)

Setup PrintCapture

To setup PrintCapture's serial port parameters go to Setup> Configuration> Serial Port.

5. Set Port to the virtual COM port assigned by the device driver for the GPIB-USB Controller 4.2.

6. The following serial port parameters are not applicable for the GPIB-USB Controller 6.0. However,

we recommend these settings just to avoid confusion:

• Set Baud Rate to 115200.

• Set Word Size to 8.

• Set Parity to NONE.

• Set Stopbits to 1.

• Set Flow Control Handshake to RTS/CTS and Automatic.

7. Set End-of-Data Processing Timeout to about 5 seconds.

1 2 3 4 5

Žádné komentáře

Prologix GPIB-USB Controller Uživatelský manuál Strana 5